Pallet stretch film baling machine, also known as strapping machine, strapping machine or strapping machine, uses strapping tape to bundle products or packages, and then tightens and combines the two ends through hot melt bonding with a heating iron. The function of the pallet stretch film baler is to reinforce the packaged items so that the items will not be scattered due to weak bundling during transportation and storage. At the same time, the items should be bundled neatly and beautifully.

How to adjust the pallet stretch film baling machine?

1. Adjustment of strap width and joint. When the strap width is uneven or when replacing straps with another width, the left and right strap insertion slots must be adjusted. If the slots are too narrow, it will be difficult to insert the straps; if they are too wide, the pallet stretch film baling machine will pack The rear strap joints will overlap unevenly. Generally, the width of the strap slot should be about 0.5-1 mm wider than the strap width.

2. Adjustment of the ironing head temperature of the pallet stretch film baling machine. The temperature of the ironing head has a great influence on the quality of the tape joint. In order to make the polypropylene strapping joints stick firmly, the knob is generally placed in the 3-5 position. Whether the temperature of the iron is appropriate, you can check the adhesion on the surface of the iron. If there are white marks on the surface of the iron, the temperature is too high; if the surface of the iron is moist, the temperature is insufficient.

3. Pallet stretch film baling machine. Adjust the bundling tightness of the package. Open the table panel and loosen the hexagon socket set screw on the large nut A by hand. Go clockwise to tighten, and counterclockwise to loosen. After the binding force is moderate, tighten the hexagon socket set screws.

4. Feeding tape length adjustment The length of the feeding tape is determined by the feeding tape length adjuster on the front panel. If the strap is too short, it is easy to tie your hands. At this time, the pallet stretch film baler can be grabbed by hand and pulled out along the feeding direction. However, it is necessary to readjust the length of the feeding tape so that the following bundling can proceed normally. Pallet Stretch Film Packing Machine If the strap is too long, it is difficult to align the position, and the Panasonic straps are easy to wrap around each other, causing the straps to be misaligned or broken. Maintenance of pallet stretch film baling machine:

1. Keep the inside of the machine clean and dry at all times.

2. It is easy to place wet or dirty objects on the machine table.

3. Avoid rolling the power cord and roll it up when not in use.

4. Keep the machine operating normally and use genuine strapping straps. The daily maintenance of the pallet stretch film baler requires the following six points:

(1) Clean the chips or dirt in the machine once a week.

(2) Clean, maintain and lubricate the upper slide plate, middle knife and front top knife as mentioned in the previous section once a month.

(3) Once every three months, after performing the above two maintenances, add some lubricating oil to all parts (shaft, center) and bearings.

(4) Replenish the oil in the reducer wheel box every two years.

(5) Please note that several parts should not be refueled: the delivery and return rollers. All straps. Sliding piece and surroundings.

(6) When refueling, do not add too much to avoid malfunction of the microswitch due to oil immersion.